Category: Easy Electronics Projects

Fuse tube light is useless what we generally think. This concept can be proven wrong by this particular project. This electronic trick let you use your fuse tube light at night lamp. The circuit comprises a bridge rectifier and a starter where, starter is used to boost up the voltage and is connected to the fuse side of tube light as shown in figure. The mains voltage is direct rectified using bridge rectifier made for four general purpose diode. The output with starter is connected to tube light as shown…

“Dry cell is not rechargeable”, this is what people think. This concept can be proven wrong by this particular project ‘Dry cell charger‘. Now here is another electronics trick to make the concept of ‘Battery Saver’ come true. The project battery sever not only charges dry cell but also enhances battery life by saving energy. The project ‘Battery saver circuit’ is considered very useful project for those, who run their appliance solely based on dry cell. Circuit Description Batter Saver Circuit:- The circuit is so simple that anyone can understand,…

The project shown here is of simple touch switch circuit using two transistor which is used to control various types of electrical appliances like electrical bulb, fan, door bell etc. The complete circuit is build around two general purpose transistors, a relay and a touch plate. The length of wire connected between touch plate and base of transistor T1 must be short as possible, where size of touch plate must not exceed the size of 1 rupee coin. Transistor T1 is used as signal amplifier where T2 is a relay…

We all are fed with the fact that dry cell is not rechargeable and it has no use once it is discharged during use. And, people simply throw it away and buy a new one. Because of this, people are forced to invest quite a lot on battery. In order to overcome this problem, here we have presented a new project ‘Dry Cell Charger’, which has been tested and verified practically. Using the circuit dry cell charger one can charge dry cell 6 to 8 times which evidently contributes to…

When using speakers, people must have faced quite a lot of problems due to failure of the speaker to produce smooth sound quality continuously. It is because speaker detects only identical frequency and does not give response to all frequency.  Particular range of low frequencies is detected by the speaker and it ignores high frequencies. Woofer or tweeter is introduced as a solution to this issue. However, if the signal from amplifier is directly fed to woofer or tweeter, then it may not produce the actual sound. And, a crossover…