Light and Touch Operated Music Door Bell

The novel circuit light and touch operated music bell used a photo transistor (T1) with an npn transistor in emitter-follower mode to increase sensitivity of the circuit. So even if very little light fall on the photo transistor, it gives a triggering pulse to SCR gate and the SCR starts conducting.

Circuit Description of Light and Touch Operated Music Bell

When SCR conducts, IC UM66 starts producing music. After the music has halted, no current flows through the SCR and the SCR switches off till the light falls again on the photo transistor.

circuit diagram of light and touch operated music bell

If the touch plate is inserted in parallel to switch SW1, as shown in circuit diagram of light and touch operated music bell. Whenever the plate is touched by someone it gives a triggering pulse to the SCR which again produces music through the IC. So the same circuit can be operated either by light or touch. Push button switch SW1 permits the circuit to be operated in the normal way, i.e. by pushing the bell switch.

Check out various other door bell project project in bestengineeringprojects.com

  1. Mains Trigger Musical Door Bell Circuit
  2. Alarm Circuit | Door Bell Circuit
  3. 12 Tones Door Bell
  4. Door Bell Circuit

PARTS LIST OF LIGHT AND TOUCH OPERATED MUSIC BELL

Resistor (all ¼-watt, ± 5% Carbon)

R1 = 2.2 KΩ

R2 = 220 Ω

Capacitor

C1 = 1000 µF, 10V (Electrolytic capacitor)

Semiconductors

IC1 = UM66 (Melody IC)

T1 = 2N5777 (Photo Transistor)

T2 = BC104 (Silicon NPN Transistor)

T3 = SL100 (general purpose, medium power NPN transistor)

SCR1 = SN204

Miscellaneous

SW1 = Push-To-On Switch

LS1 = 8 Ω speaker

B1 = 3V to 5V DC

Touch Plate

Leave a Comment